![]() |
Line > Vertical (Draw Menu) |
www.CAD6.com |
This command draws a vertical line. "Vertical" takes the current view into account, so it is always vertical with respect to the screen!
The position of the vertical line is determined by a reference point through which the reference straight line should run. This reference point can be entered by clicking the mouse at any point within the drawing.
After entering the reference point, a straight line running horizontally through the start point appears. This is referred to as the "Reference straight line".
The start point of the line can be entered by clicking the mouse anywhere in the drawing. A perpendicular is dropped from this position to the reference straight line to determine the end point of the new line.
The end point of the line can be entered by clicking the mouse anywhere in the drawing. A perpendicular is dropped from this position to the reference straight line to determine the end point of the new line.
The line is assigned to the current layer. In addition, it contains a reference to the current pen.
|
CAD6studio Release 2024.1 - Copyright 2024 Malz++Kassner® GmbH