Line > Angle to Line (Draw Menu)

This command draws a line which runs at a specific angle to a line of any type.

After choosing this command, a dialog appears into which the angle to be used can be entered.

Any line in an existing object can be identified as a reference line, including a side of a rectangle or a circle segment leg.

After identification, a straight line appears which runs at the previously entered angle to the identified line and moves with the mouse. This line is referred to as the "Reference Straight Line".

The reference point can be entered by clicking the mouse anywhere in the drawing. It determines the position of a straight line on which the final line will lie.

The start point of the line can be entered by clicking the mouse anywhere in the drawing.

The end point of the line can be entered by clicking the mouse anywhere in the drawing. A perpendicular is dropped from this position to the reference straight line to determine the end point of the new line.

The line is assigned to the current layer. In addition, it contains a reference to the current pen.